Reference Guide 612 Document #: LTRT-17939
Mediant MSBR
Command Mode
Privileged User
Example:
The following example saves the IPv6 prefix but does not advertise it.
(config-data)# interface vlan 1
(conf-if-GE 0/0)# ipv6 dhcp-server dns-server 2001::1
75.1.6 interface
This command enters the WAN interface that is connected to the WAN. The DHCPv6 client’s
default behavior is to set a default route through the interface running the client and
connected to DHCPv6 server. However, that behavior can be overridden by the following CLI
commands:
Syntax
# interface <WAN interface>
Command Mode
Privileged User
Example
In this example, a host is connected to the LAN interface of MSBR on VLAN 1 and the auto-
created default route is cancelled.
MSBR# configure data
MSBR(config-data)# interface vlan 1
MSBR(conf-if-VLAN 1)# no ipv6 nd autoconfig default-route
To Next Page
Loading...
