AudioCodes Mediant MSBR Series

Reference Guide 166 Document #: LTRT-17939
Mediant MSBR
6.12.8 show voip interface
This command displays information (basic configuration, status and Performance Monitoring)
of a specified telephony interface (E1/T1, BRI or FXS/FXO).
Syntax
show voip interface {e1-t1|bri|fxs-fxo} <Module>/<Port>
Command Description
e1-t1
Displays information on a specified E1/T1 interface.
bri
Displays information on a specified BRI interface.
fxs-fxo
Displays the current status, main PM parameters and main
configuration parameters to a specific analog interface
(FXS or FXO
module
Configures the module slot index as shown on the front
panel
port
Configures the module's analog port number (FXS/FXO) or
trunk port number (E1/T1 or BRI) to display.
Command Mode
Basic User and Privileged User
Note
 Parameters displayed depend on the PSTN protocol type.
 The command is applicable to devices supporting analog and/or digital PSTN
interfaces.
Example
Displaying information of the E1/T1 interface of trunk port 1 of trunk module 3:
show voip interface e1-t1 3/1
show voip interface e1-t1 3/1
-------------------------------
module/port: 3/1
trunk number: 0
protocol: t1_transparent
state: not active
alarm status: LOS 1, LOF 0, RAI 0, AIS 0, RAI_CRC 0
loopback status: no loop
send alarm status: no alarm
main performance monitoring counters collected in the last 470
seconds:
BitError: 0 EBitErrorDetected: 0
CRCErrorReceived: 0 LineCodeViolation: 0
ControlledSlip: 0 ControlledSlipSeconds: 0
ErroredSeconds: 0 BurstyErroredSeconds: 0