AudioCodes Mediant MSBR Series User Manual

Reference Guide 422 Document #: LTRT-17939
Mediant MSBR
Command Description
cot-detector-enable
Enables COT (Continuity Tones) detection and generation.
disable-nat-traversal
{0|1|2|3}
Defines the NAT mode.
inbound-media-latch-
mode
Defines the handling of incoming media packets from non-
expected address/port.
silk-max-average-
bitrate
Defines the SILK coder maximal average bit rate.
silk-tx-inband-fec
Enables the SILK FEC (Forward Error Correction).
Command Mode
Privileged User
Example
This example defines the NAT mode so that NAT traversal is performed only if the UA is
located behind NAT:
(config-voip)# media settings
(media-settings)# disable-nat-traversal 0
(media-settings)# activate
63.6 tdm
This command configures various TDM clock synchronization and bus.
Syntax
(config-voip)# media tdm
(media-tdm)#
Command Description
TDMBusClockSource|{MVI
P|atm-oc12|atm-
oc3|atm-oc3-
b|bits|h110-A|h110-
b|internal|net-
reference-1|net-
reference-
2|network|network-
b|network-ds3-
1|network-ds3-
2|network-ds3-3|sc-
2m|sc-4m|sc-8m}
Defines the clock source on which the device
synchronizes.
bus-type
Defines the TDM bus interface.
idle-abcd-pattern
Defines ABCD (CAS) pattern applied on signaling bus
before it is changed.

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English