AudioCodes Mediant MSBR Series User Manual

Reference Guide 538 Document #: LTRT-17939
Mediant MSBR
73.4.16 Multilink Interfaces (MLP over T1 WAN)
This section describes the Multilink interfaces commands. The multilink interface holds all
relevant data characteristics for a virtual bundle of MLP interface/s.
73.4.16.1 napt
This command sets the NAPT (Network Address Port Translation) on the Multilink interface.
Syntax
napt
Default
By default T1 interfaces use NAPT.
Command Mode
Privileged User
Example
This example sets the Multilink interface 0 to use NAPT:
(conf-if-multilink 0)#napt
73.4.16.2 ppp bundle-id
This command associates the current multilink interface with a virtual bundle id number.
Note: You can configure an identical virtual bundle for the multilink WAN interface
and the MLP over T1 serial WAN interface, where the identifier <bundle-id> is
specified for both interfaces. In the example below and in the example in Section
41.5.15.14 on page 537, <bundle-id> is specified as ‘8’.
Syntax
ppp bundle-id <id>
Command Description
<id> Defines the bundle-id (0-255).
Default
By default, the bundle id is set to the multilink interface number.
Command Mode
Privileged User

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English