Reference Guide 536 Document #: LTRT-17939
Mediant MSBR
Syntax
authentication username <username>
Command Description
username Defines the username string
Default
By default, the username is set to ‘user’.
Command Mode
Privileged User
Example
This example sets the username on the PPP serial interface 0/0:
(conf-if-serial-ppp 0/0)# authentication username JohnA
73.4.15.13 authentication password (PPP/MLP over T1)
This command sets the password to be used by this PPP/MLP serial interface during the
authentication phase of the PPP negotiation.
Syntax
authentication password <password>
Command Description
<password> Defines the password string
Default
By default, password is set to ‘password’.
Command Mode
Privileged User
Example
This example sets the password on the MLP serial interface 0/1:
(conf-if-serial-mlp 0/1)# authentication password qwerty
To Next Page
Loading...
