AudioCodes Mediant MSBR Series

Reference Guide 592 Document #: LTRT-17939
Mediant MSBR
74.4.2 Spanning Tree Interface Commands
The sub-section below describes Spanning Tree Interface commands.
74.4.2.1 spanning-tree
This command enables/disables the spanning tree on a specific interface.
Syntax
spanning-tree
no spanning-tree
Default
NA
Note
Under configure terminal
Command Mode
Privileged User
Examples:
To enable the spanning-tree on interface 5/1:
(conf-if-FE 5/1)# spanning-tree
To disable the spanning-tree on interface 5/1:
(conf-if-FE 5/1)# no spanning-tree
74.4.2.2 spanning-tree priority
This command sets the priority of the interface.
Syntax
spanning-tree priority <value>
Command Description
<value>
Sets the value in the range of 0-240. Must be a multiple of
16.
Default
NA
Note
Under configure terminal