Reference Guide 310 Document #: LTRT-17939
Mediant MSBR
Example
This example configures the OAMP, Media and Control network interface:
(config-network)# interface network-if 0
(network-if-0)# application-type oamp-media-control
(network-if-0)# mode ipv4-manual
(network-if-0)# ip-address 10.15.7.96
(network-if-0)# prefix-length 16
(network-if-0)# gateway 10.15.0.1
(network-if-0)# underlying-dev vlan1
45.2 interface osn
This command configures the Open Solutions Network (OSN) interface.
Syntax
(config-network)# interface osn
(conf-sys-if-OSN)#
Command Description
native-vlan
Configures the OSN Native VLAN ID. When set to 0
(default), the OSN uses the device's OAMP VLAN ID.
When set to any other value, it specifies a VLAN ID
configured in the Ethernet Devices table and which is
assigned to a Media and/or Control application in the IP
Interfaces table.
shutdown
Disables the Ethernet port of the internal switch that
interfaces between the Gateway/SBC and OSN.
Command Mode
Privileged User
Example
This example configures the network interfaces:
(config-network)# interface osn
(conf-sys-if-OSN)# native-vlan 1
To Next Page
Loading...
