Version 7.2 537 Mediant MSBR
Reference Guide 73. WAN Access Commands
73.4.15.14 multilink bundle-id (MLP over T1)
This command associates the current MLP serial interface to a virtual bundle id. Setting more
than one serial interface to the same bundle id bonds both interfaces under the same virtual
bundle.
Note: You can configure an identical virtual bundle for the MLP over T1 serial WAN
interface and the Multilink WAN interface, where <bundle-id> is specified for both
interfaces. In the example below and in the example in Section 41.5.16.2 on page
538, <bundle-id> is specified as ‘8’.
Syntax
multilink bundle-id <id>
Command Description
<id> Defines the bundle-id (0-255).
Default
No default value exists; you must specify a bundle id.
Command Mode
Privileged User
Example
This example associates a MLP serial interface 0/1 to logical bundle 0:
(conf-if-serial-mlp 0/1)#multilink bundle-id 8
To Next Page
Loading...
