AudioCodes Mediant MSBR Series - Match Priority

Version 7.2 615 Mediant MSBR
Reference Guide 75. Layer-3 Commands
Interface Type (ifname) Interface ID
pppoe PPPoE interface ID [1-3]
pptp PPTP ID [0-99]
vlan Vlan ID [1-3999]
loopback Loopback ID [1-5]
bvi Bridge interface [1-255]
Default
NA
Command Mode
Privileged User
Example
This example enters a specific match-map input configuration that will apply to all interfaces.
(config data)# qos match-map input sip_incoming
This example enters a specific match-map input configuration that will apply only to the vlan
7 interface.
(config-data)# qos match-map output sip_outgoing vlan 7
75.1.7.4 match priority
This command defines the priority to match on the specified match-map. Use the no form of
this command to remove a match priority.
Syntax
match priority <priority value>
Command Description
priority value Defines a priority value to match (0-7).
Default
NA
Command Mode
Privileged User
Example
This example configures the priority 5 match-map to match traffic with priority
value 5.