AudioCodes Mediant MSBR Series User Manual (English)

To Next Page

To Previous Page

Version 7.2 527 Mediant MSBR

Reference Guide 73. WAN Access Commands

Syntax

loopback <traffic source> <loopback location>

loopback <traffic source> <loopback location> <timeout>

Command Description

<traffic source> Defines the traffic source to be looped back:

 ‘remote’ – loopback ingress traffic.

 ‘local’ – loopback egress traffic.

Defines where the loop is performed in the T1 WAN

Interface:



‘line’ – loop is done in the csu.

On the local loopback only.

Specifies the timeout (in seconds) after the local loopback

releases. Default timeout is 180 seconds.

Default

By default, there is no loopback.

Command Mode

Privileged User

Example

This example set the remote line loopback on T1 Port 0/0.

(conf-if-t1 0/0)# loopback remote line

73.4.14.8 ber-test

This command specifies the Bit Error Rate test on the current T1 WAN interface.

Syntax

The syntax for this command includes several variations:

ber-test <channels group> <error rate> <pattern type>

ber-test <channels group> <error rate> <pattern type> <timeout>

ber-test <channels group> <error rate> <pattern type> forever

Command Description

 Specifies the slot number within the range 1-24, on

which the BER test runs. (See channel-group

command for examples).

<error rate> Specifies the rate of injected errors to the BER interface:

 0 – no errors injected.

Other manuals for AudioCodes Mediant MSBR Series

Need help?

Do you have a question about the AudioCodes Mediant MSBR Series and is the answer not in the manual?

General