Reference Guide 386 Document #: LTRT-17939
Mediant MSBR
Command Description
If add carrier identification code as prefix.
add-ph-cntxt-as-pref
Adds the phone context to src/dest phone number as
prefix.
add-prefix-for-isdn-
hlc-fax
If set and incoming ISDN SETUP contains High Layer
Compatability IE with Facsimile, prefix FAX will be added
to received Calling number.
alt-map-tel-to-ip
Enables different number manipulation rules for redundant
calls.
inbound-map-set
Inbound manipulation set ID for GW -
for all incoming INVITE requests.
Set the IP-to-TEL Redirect Reason.
map-ip-to-pstn-refer-
if set to 1, manipulate destination number from REFER-
in TDM blind transfer.
outbound-map-set
Assigns the Manipulation Set ID for manipulating all
outbound INVITE messages.
prefix-2-ext-line
FXS: If enabled (1) and Prefix2ExtLine is detected, it is
added to the dial number as prefix
Perform Additional IP2TEL Destination Manipulation
Perform Additional IP2TEL Source Manipulation
swap-tel-to-ip-phone-
Swaps calling and called numbers received from Tel side.
tel-to-ip-dflt-redir-
Tel-to-IP Default Redirect Reason.
tel2ip-dst-nb-map-
Tel to IP Destination Number Mapping Dial Plan Index.
Tel-to-IP Redirect Reason.
tel2ip-src-nb-map-
Tel to IP Source Number Mapping Dial Plan Index.
tel2ip-src-nb-map-
Tel to IP Source Number Mapping Dial Plan Mode.
use-refer-by-for-
If set to 1, use a number from Referred-By URI, as a
calling number in outgoing Q.931 SETUP.
Command Mode
Privileged User
59.5.12 src-number-map-ip2tel
This command configures the Source Phone Number Manipulation for IP-to-Tel Calls table,
which lets you define manipulation rules for manipulating the source number for IP-to-Tel
calls.