AudioCodes Mediant MSBR Series - Port Monitoring Commands; Port-Monitor

Reference Guide 588 Document #: LTRT-17939
Mediant MSBR
74.3 Port Monitoring Commands
Port monitoring allows the user to reflect traffic from each Ethernet LAN port to any other
single LAN or microprocessor port. Monitoring of traffic is useful when trying to analyze the
traffic or when debugging network problems. The Mediant 800 MSBR allows monitoring of
egress traffic, ingress traffic, or both directions.
74.3.1 port-monitor
This command configures source ports. This is performed after you have chosen your
destination port.
Syntax
port-monitor <type> <slot/port> <direction>
Command Description
Type Defines the source Interface type FastEthernet/GigabitEthernet.
slot/port Defines the source Interface slot number and port number.
direction Defines the monitoring direction - Ingress/Egress/Both.
Example
This example defines a key to a peer ip.
(conf-if-GE 4/3)# port-monitor GigabitEthernet 4/1 ingress
(conf-if-GE 4/3)# port-monitor FastEthernet 5/2 egress
(conf-if-GE 4/3)# port-monitor GigabitEthernet 4/4 both-direction