Reference Guide 774 Document #: LTRT-17939
Mediant MSBR
76.5.6 ip access-group
This command associates an access list with an IP interface. Refer to the "access-list"
command documentation for more information.
To remove an access list association, use the no format of the command.
Syntax
ip access-group <acl-id> in
ip access-group <acl-id> out
no ip access-group <acl-id>
Command Description
<acl-id> Identifies the access list to use (number or name).
in The access list will control inbound traffic on the interface.
out
The access list will control outbound traffic on the interface.
Default
The default setting for IP interfaces is no access-group, i.e. unlimited traffic.
Command Mode
This command is issued in interface context.
Example
This example associates an access list with a VLAN interface:
(conf-if-VLAN 1)# ip access-group 2001 in
To Next Page
Loading...
