Version 7.2 627 Mediant MSBR
Reference Guide 75. Layer-3 Commands
(conf-s-map)# queue sip_wan_outgoing
This example enters a lan output service map default queue configuration menu.
(conf-s-map)# queue default
75.1.7.20 priority
This command provides support for scenarios where the device is used as a bridging device
(Layer 2) and IEEE 802.1p priority marking for the bridged traffic is required. When this is
used, outgoing packets belonging to a specified VLAN interface are marked with the
configured priority value.
Syntax
priority <priority level>
Command Description
priority level Defines the priority level which can be any value from 0
(lowest) through 7 (highest).
Default
NA
Command Mode
Privileged User
Example
This example sets the priority level to "7".
(config-data)# interface vlan 1
(conf-if-VLAN 1)# priority 7
To Next Page
Loading...
