AudioCodes Mediant MSBR Series User Manual

Version 7.2 579 Mediant MSBR
Reference Guide 74. Layer-2 (LAN) Commands
Note
If the port is in the trunk mode, this command will not alter the switchport mode to ‘Access’.
Instead it will save the value to be applied when the port does switch to Access mode.
Command Mode
Privileged User
Related Commands
switchport mode
Example
This example sets the switchport mode to static access and makes the GigabitEthernet
interface 4/2 port a member of VLAN 3:
(config-data)# interface gigabitethernet 4/2
(conf-if-GE 4/2)# switchport access vlan 3
74.2.8.3 switchport trunk allowed vlan
This command is used to configure the VLANs available on the trunk (when the interface is
in trunking mode).
Syntax
switchport trunk allowed vlan add <vlan id>
switchport trunk allowed vlan remove <vlan id>
Command Description
add Adds an entry to the list of allowed VLANs.
remove Removes an entry from the list of allowed VLANs.
<vlan id> Specifies a valid VLAN interface ID. Range is 1 to 3999.
Default
NA
Note
VLAN ID values range from 1 to 3999.
Command Mode
Privileged User

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English