AudioCodes Mediant MSBR Series User Manual

Version 7.2 251 Mediant MSBR
Reference Guide 25. snmp
25 snmp
This command configures Simple Network Management Protocol (SNMP) and includes the
following subcommands:
 settings (see Section 25.1)
 trap (see Section 25.2)
 trap-destination (see Section 25.3)
 v3-users (see Section 25.4)
25.1 snmp settings
This command configures various SNMP settings.
Syntax
(config-system)# snmp settings
(snmp)#
Command Description
activate-keep-alive-trap
[interval]
Enables a keep-alive trap for the agent behind
NAT.
delete-ro-community-string
Deletes the read-only community string.
delete-rw-community-string
Deletes the read-write community string.
disable {no|yes}
Enables SNMP.
engine-id
Configures the SNMP Engine ID. 12 HEX Octets
in the format: xx:xx:...:xx
port
Configures the port number for SNMP requests
and responses.
ro-community-string
Configures a read-only community string.
rw-community-string
Configures a read-write community string.
snmp-acl {community
string}
Sets the configuration.
sys-contact
Configures the contact person for this managed
node (string) .
sys-location
Configures the physical location of the node
(string).
sys-name
Configures the sysName as descibed in MIB-2
(string).
sys-oid
Configures the base product system OID - SNMP
SysOid (string).
trusted-managers {0-4} <IP
Address>
Configures the IP address of Trusted SNMP
Managers.
wan-snmp-allow {off|on}
Enables WAN access to the management
interface via SNMP.

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English