AudioCodes Mediant MSBR Series

Version 7.2 317 Mediant MSBR
Reference Guide 49. nqm
49 nqm
This command configures the device to monitor the quality of the network path (network
quality monitoring - NQM) between it and other AudioCodes devices. The path monitoring is
done by sending packets from a "sender" device to a "responder" device and then calculating
the round-trip time (RTT), packet loss (PL), and jitter.
The command includes the following subcommands:
 probing-table (see Section 49.1)
 responder-table (see Section 49.2)
 sender-table (see Section 49.3)
Note: NQM is applicable only to Mediant 800 MSBR.
49.1 nqm probing-table
This command configures the polling attributes (duration and frequency).
Syntax
(config-network)# nqm probing-table < Index >
(probing-table-<Index>)# < Command>
Command Description
duration
Configures the duration of the probing session (in
seconds).
frequency
Configures the time interval between the start of two
consecutive probing sessions (in seconds).
history-entries
Configures the number of probing result entries to keep in
the history file.
life-span
Configures the life span of this probe (in seconds).
probe-name
Configures a descriptive name for this probe.
start-time
Configures the start time of this probe.
Command Mode
Privileged User
Example
This example configures a row in the Probing table:
(config-network)# nqm probing-table 0
(probing-table-0)# probe-name voip_probe_1
(probing-table-0)# start-time now