Version 7.2 287 Mediant MSBR
Reference Guide 39. access-list
39 access-list
This command configures the Firewall table, which lets you define firewall rules that define
network traffic filtering rules.
Syntax
(config-network)# access-list <Index>
(access-list-<Index>)#
Command Description
allow-type
Configures the firewall action if the rule is matched.
Configures the allowed traffic burst in bytes.
byte-rate
Configures the allowed traffic bandwidth in bytes per
second.
Configures the destination ending port.
network-interface-name
Configures the IP Network Interface (string) for which the
rule applies.
Configures the maximum allowed packet size.
prefixLen
Configures the prefix length of the source IP address
(defining a subnet).
Configures the IP user-level protocol.
source-ip
Configures the source IP address from where the packets
are received.
src-port
Configures the source port from where the packets are
received.
Configures the destination starting port.
use-specific-interface
Use the rule for a specific interface or for all interfaces.
Command Mode
Privileged User
Example
This example configures a firewall rule allowing a maximum packet size of 1500 bytes on the
"ITSP" network interface:
(config-network)# access-list
(access-list-0)# use-specific-interface enable
(access-list-0)# network-interface-name ITSP
(access-list-0)# allow-type allow
(access-list-0)# packet-size 1500