AudioCodes Mediant MSBR Series - Debug Test-Call

Reference Guide 5. Debug Commands
Version 7.2 89 Mediant MSBR
5.34 debug test-call
This command initiates and terminates a call from the device to a remote destination to test
whether connectivity, media, etc., are correct. Sends a SIP INVITE message and then
manages the call with the call recipient.
Syntax
# debug test-call ip
 Configures a test call:
# debug test-call ip dial from {<Calling Number> to <Called
Number> [dest-address <IP Address>] [sip-interface <SIP Interface
ID>]|id <Test Call Table Index>}
 Configures a test call:
# debug test-call ip set called-number <Called number> caller-
id <Caller ID> calling-number <Calling number> dest-address
<IP Address> play <Playback> sip-interfaces <SIP Interface ID>
timeout <Disconnection timeout> transport-type
 Terminates a test call:
# debug test-call ip drop {<Calling Number>|id <Test Call
Table Index>}
 Displays test call configuration:
# debug test-call ip show
Command Description
ip
Configures and initiates a test call to an IP address.
 dial (Dials using specified parameters)

from (Configures the calling number):
[NUMBER] (Calling number)
id (uses the Test Call Rules table entry)
 drop (Terminates the latest outgoing test call):

[Calling Number] (Terminates outgoing test call by
number)

id (Terminates outgoing test calls by table index)
 set (Sets test options):

called-number (Called number)

caller-id (Caller ID)

calling-number (Calling number)

dest-address (Target host)

play (Sets playback)

sip-interfaces (Sets SIP interfaces to listen on)

timeout (Disconnection timeout (seconds))

transport-type (Transport type)

show
(Displays test call configuration)