Reference Guide 398 Document #: LTRT-17939
Mediant MSBR
(trunk-group-setting-0)# trunk-group-name PSTN
(trunk-group-0)# trunk-group-id 1
(trunk-group-0)# channel-select-mode always-ascending
(trunk-group-0)# activate
59.10 voice-mail-setting
This command configures the voice mail parameters.
Syntax
(config-voip)# gateway voice-mail-setting
(gw-voice-mail)#
Command Description
dig-to-ignore-dig-
pattern
A digit (0-9,A-D,* or #) that if received as Src (S) or
Redirect (R), the digit is ignored and not added to that
number. Used in DTMF VoiceMail.
disc-call-dig-ptrn
Disconnect call if digit string is received from the Tel side
during session.
enable-smdi
{SMDI_PROTOCOL_BELCORE
|SMDI_PROTOCOL_ERICSSO
N|SMDI_PROTOCOL_NEC_IC
Enables the Simplified Message Desk Interface (SMDI).
Digit pattern to indicate external call (PBX to voice mail)
fwd-bsy-dig-ptrn-ext
Digit pattern to indicate Call Forward on busy (PBX to
voice mail)
fwd-bsy-dig-ptrn-int
Digit pattern to indicate Call Forward on busy (PBX to
voice mail)
fwd-dnd-dig-ptrn-ext
Digit pattern to indicate Call Forward on Do Not Disturb
(PBX to voice mail)
fwd-dnd-dig-ptrn-int
Digit pattern to indicate Call Forward on Do Not Disturb
(PBX to voice mail)
fwd-no-ans-dig-ptrn-
Digit pattern to indicate Call Forward on no answer (PBX
to voice mail)
fwd-no-ans-dig-ptrn-
Digit pattern to indicate Call Forward on no answer (PBX
to voice mail)
fwd-no-rsn-dig-ptrn-
Digit pattern to indicate Call Forward with no reason (PBX
to voice mail)
fwd-no-rsn-dig-ptrn-
Digit pattern to indicate Call Forward with no reason (PBX
to voice mail)
Digit pattern to indicate internal call (PBX to voice mail)
Line transfer mode.
mwi-off-dig-ptrn
Digit pattern to notify PBX about no messages waiting for
extension (added as prefix)