EasyManuals Logo

AudioCodes Mediant MSBR Series User Manual

AudioCodes Mediant MSBR Series
801 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
Reference Guide 60 Document #: LTRT-17939
Mediant MSBR
5.6.3.1 debug capture voip interface
This command captures network traffic on a VoIP network interface (VLAN).
Syntax
# debug capture voip interface vlan <VLAN ID> proto <Protocol
Filter> host <Host Filter> {port <Port Filter>
[tftp-server <TFTP Server IP Address>|ftp-server <FTP Server IP
Address>]}
 To start and stop the capture:
1. After typing the above command, press Enter.
2. To stop the capture, press Ctrl+C.
Command Description
vlan
Configures the VLAN ID of the network interface on which
to start the debug capture.
proto
Configures a protocol filter:
• all (all protocols)
• arp (ARP packets)
• icmp (ICMP packets)
• ip (IP packets)
• ipv6 (IPv6 packets)
• tcp (TCP packets)
•
udp (UDP packets)
host
Configures a host (IP address) from/to which the packets
are captured. To specify all hosts, enter
any
.
port
(Optional) Configures a port filter: 1-65535 or any (all
ports). When using arp or icmp as the protocol filter,
port filter cannot be used and the only valid value is
any
.
ftp-server
(Optional) Configures the IP address of the FTP server to
which the captured traffic file (in .pcap file format) is sent.
If not specified, captured traffic is displayed in the CLI
console.
After running the command, press Ctrl+C when you want
the capture to end and the captured traffic file to be sent
to the server.
Note: The FTP server's IP address must be accessible
from one of the VoIP network interfaces for the capture
file to be successfully uploaded to the server. Ping the
server to make sure it's accessible.
tftp-server
(Optional) Configures the IP address of the TFTP server
to which the captured traffic file (in .pcap file format) is
sent. If not specified, captured traffic is displayed in the
CLI console.
After running the command, press Ctrl+C when you want
the capture to end and the captured traffic file to be sent
to the server.
Note: The TFTP server's IP address must be accessible
from one of the VoIP network interfaces for the capture

Table of Contents

Other manuals for AudioCodes Mediant MSBR Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant MSBR Series and is the answer not in the manual?

AudioCodes Mediant MSBR Series Specifications

General IconGeneral
BrandAudioCodes
ModelMediant MSBR Series
CategoryNetwork Router
LanguageEnglish

Related product manuals