AudioCodes Mediant MSBR Series User Manual

Version 7.2 523 Mediant MSBR
Reference Guide 73. WAN Access Commands
73.4.13 T1 WAN Commands
This section describes the commands for the T1 WAN interface. The T1 WAN interface is
one of three WAN interfaces of the Mediant 500 MSBR and Mediant 800 MSBR.
The other WAN interfaces are SHDSL (see Section 41.5 on page 514) and the Ethernet WAN
interface (see the relevant sections above).
The T1 WAN interface supports up to two physical T1 ports; 0 and 1.
This section includes the following topics:
 T1 Physical Interfaces. See below.
 Serial Interfaces. See Section 41.5.15 on page 529.
 Multilink Interfaces (MLP over T1 WAN). See Section 41.5.16 on page 538.
The commands described in the above (Sections 40 to Section 42.3) are also applicable to
the T1 WAN interface.
73.4.14 T1 Physical Interfaces
This section describes the WAN T1 Physical Interface commands.
Note: You can configure the WAN T1 physical interface and the WAN serial interface
on the same physical WAN port, where the same identifier <slot>-<port> is specified
for both interfaces. In the examples described in this section and in section 41.5.15
on page 529, <slot> / <port> is specified as either ‘0/0’ and ‘0/1’.
73.4.14.1 channel-group
This command specifies the active TDM slots within the T1 frames.
Syntax
channel-group <slot number>,<slot number>
channel-group <slot number>-<slot number>
Command Description
<slot number> Defines the slot number within the range 1-24.
Default
By default all slots are active  1-24.
Command Mode
Privileged User

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English