AudioCodes Mediant MSBR Series - 37 Test-Call; Settings; Test-Call-Table

Version 7.2 281 Mediant MSBR
Reference Guide 37. test-call
37 test-call
This command configures test calls and includes the following subcommands:
 settings (see Section 37.1)
 test-call-table (see Section 37.2)
37.1 settings
This command configures various test call settings.
Syntax
(config-troubleshoot)# test-call settings
(test-call)#
Command Description
testcall-dtmf-string
Configures a DTMF string (tone) that is played for
answered test calls.
testcall-id
Configures the incoming test call prefix that identifies it as
a test call.
Command Mode
Privileged User
Example
This example configures a test call ID:
(config-troubleshoot)# test-call
(test-call)# testcall-id 03
37.2 test-call-table
This command configures the Test Call Rules table, which allows you to test SIP signaling
(setup and registration) and media (DTMF signals) of calls between a simulated phone on
the <device> and a remote IP endpoint.
Syntax
(config-troubleshoot)# test-call test-call-table <Index>
(test-call-table-<Index>)#
Command Description
application-type {gw|sbc}
Application type.
auto-register {disable|enable}
Automatic register.
bandwidth-profile
Bandwidth Profile.