Reference Guide 5. Debug Commands
Version 7.2 69 Mediant MSBR
5.15 debug dynamic-routing
This command configures debugging the MSBR device's memory storage capabilities.
Syntax
# debug dynamic-routing
Command Description
Debugs using all the commandss listed below.
Debugs Border Gateway Protocol memory.
Debugs Library memory.
Debugs Open Shortest Path First (OSPF) memory.
ospf6
Debugs Open Shortest Path First for Internet Protocol
version 6 (OSPF6) memory.
Debugs Routing Information Protocol (RIP) memory.
ripng
Debugs RIPng (RIP next generation), defined in RFC
2080, extends RIPv2 to support next generation Internet
Protocol, IPv6.
vrf
Associates memory debug messages with a VRF. Enter
the name of the VRF table with which to associate the
debug messages.
zebra
Debugs Zebra routing software which provides TCP/IP
based routing services with support from routing
protocols RIP, OSPF and BGP (see above). Zebra also
supports IPv4 and IPv6 routing protocols.
Command Mode
Privileged User
Note
This command is applicable only to data-router functionality.
Example
This example shows how to configure debugging OSPF memory:
# debug dynamic-routing memory ospf
OSPF if info : 12
OSPF if params : 12
To Next Page
Loading...
Need help?
General
