Version 7.2 217 Mediant MSBR
Reference Guide 11. cli-settings
11 cli-settings
This command configures various CLI settings.
Syntax
(config-system)# cli-settings
(cli-settings)#
Command Description
default-window-
height
Defines the number (height) of output lines displayed
in the CLI terminal window. This applies to all new
CLI sessions and is preserved after device resets.
The valid value range is -1 (default) and 0-65535:
ï‚§ A value of -1 means that the parameter is
disabled and the settings of the CLI command
window-height is used.
ï‚§ A value of 0 means that all the CLI output is
displayed in the window.
ï‚§ A value of 1 or greater displays that many output
lines in the window and if there is more output,
the “—MORE—" prompt is displayed. For
example, if you configure the parameter to 4, up
to four output lines are displayed in the window
and if there is more output, the “—MORE—"
prompt is displayed (at which you can press the
spacebar to display the next four output lines).
Note: You can override this parameter for a specific
CLI session and configure a different number of
output lines, by using the window-height CLI
command in the currently active CLI session.
idle-timeout
{off|on}
Configures the maximum duration (in minutes) that a
CLI session may remain idle, before being
disconnected.
password-obscurity
Hides all passwords in the output of the show
running-config command.
privilege-password
Configures the password for the privilege (Enable)
mode.
Enables secure access using SSH.
ssh-acl
Assigns an Access List entry (client) permitted to
access the SSH interface. The Access List is
configured by the access-list command.
ssh-admin-key
Configures the RSA public key (hexadecimal) for
SSH client login.
ssh-last-login-
Enables the display of the last address from which
the user logged into the SSH server.
ssh-max-binary-
Configures the maximum SSH binary packet size.