Reference Guide 356 Document #: LTRT-17939
Mediant MSBR
(automatic-dialing-0)# auto-dial-status enable
(automatic-dialing-0)# dst-number 9764401
59.2.3 call-forward
This command configures the Call Forward table, which lets you define call forwarding per
FXS or FXO port for IP-to-Tel calls.
Syntax
(config-voip)# gateway analog call-forward <Index>
(call-forward-<Index>)#
Command Description
destination
Defines the telephone number or URI (<number>@<IP
address>) to where the call is forwarded.
no-reply-time
If you have set type for this port to no-answer or on-busy-
or-no-answer, then configure the number of seconds the
<device> waits before forwarding the call to the specified
phone number.
type {deactivate|dont-
disturb|no-answer|on-
busy|on-busy-or-no-
Defines the condition upon which the call is forwarded.
Command Mode
Privileged User
Note
To view the port-module numbers and port type, enter the display command at the index
prompt, for example:
(call-forward-0)# display
Example
This example configures unconditional call forwarding to phone 9764410:
(config-voip)# gateway analog call-forward 0
(call-forward-0)# destination 9764410
(call-forward-0)# type unconditional
(call-forward-0)# activate
59.2.4 call-waiting
This command configures the Call Waiting table, which lets you enable call waiting per FXS
port.
Syntax
(config-voip)# gateway analog call-waiting <Index>
(call-waiting-<Index>)#
To Next Page
Loading...
Need help?
General
