AudioCodes Mediant MSBR Series User Manual

Reference Guide 406 Document #: LTRT-17939
Mediant MSBR
Command Description
local-isdn-rbt-src
If the ringback tone source is not IP, who should supply the
Ringback tone.
ovrlp-rcving-type
Select reception type of overlap dialing from ISDN side
pi-in-rx-disc-msg
Configure PIForDisconnectMsg to overwrite PI value
received in ISDN Disconnect message
pi-to-isdn
Override the value of progress indicator to ISDN side in
ALERT PROGRESS and PROCEEDING messages
play-rbt-to-trk
Enable ringback tone playing towards trunk side.
protocol
Sets the PSTN protocol to be used for this trunk.
pstn-alrt-timeout
Max time (in seconds) to wait for connect from PSTN
rmv-calling-name
Remove Calling Name For Trunk.
tei-assign-trigger
Bit-field defines when TEI assignment procedure is
invoked
tei-config-p2mp
TEI value for P2MP BRI trunk.
tei-config-p2p
TEI value for P2P BRI trunk.
tei-remove-trigger
Bit-field defines when TEI should be removed.
trace-level
Set the BRI trunk trace level.
trk-xfer-mode-type
Type of transfer the PSTN/PBX supports.
Command Mode
Privileged User
Example
This example configures BRI to NI2 ISDN protocol type (51):
(config-voip)# interface bri 2/1
(bri 2/1)# protocol 51
(bri 2/1)# activate
61.2 e1-t1
This command configures E1/T1 interfaces.
Syntax
(config-voip)# interface e1-t1 <Slot (Module)/Port>
(e1-t1 <Slot/Port>)#
Command Description
b-ch-negotiation
ISDN B-Channel negotiation mode
b-channel-nego-for-
trunk
ISDN B-Channel negotiation mode for trunk.

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English