Reference Guide 360 Document #: LTRT-17939
Mediant MSBR
(enable-did-0)# display
Example
This example enables Japan DID:
(config-voip)# gateway enable-did 0
(enable-did-0)# did enable
(enable-did-0)# activate
59.2.9 fxo-setting
This command configures various FXO parameters.
Syntax
(config-voip)# gateway analog fxo-setting
(gw-analog-fxo)#
Command Description
answer-supervision
Enables sending a SIP 200 OK when speech, fax
or modem is detected.
dialing-mode {one-stage|two-
Global parameter configuring the dialing mode for
IP-to-Tel (FXO) calls
disc-on-bsy-tone-c {off|on}
Global parameter enabling call disconnection
when a busy tone is detected
disc-on-dial-tone {off|on}
Determines whether the device disconnects a call
when a dial tone is detected from the PBX
fxo-autodial-play-bsytn
{off|on}
Determines whether the device plays a busy /
reorder tone to the PSTN side if a Tel-to-IP call is
rejected by a SIP error response (4xx, 5xx or 6xx).
If a SIP error response is received, the device
seizes the line (off-hook), and then plays a busy /
reorder tone to the PSTN side (for the duration
defined by the parameter TimeForReorderTone)
fxo-dbl-ans {off|on}
Enables FXO Duoble Answer.{@}all incoming
TEL2IP call are refused
fxo-number-of-rings
Configures the number of rings before the d
FXO interface answers a call by seizing the line.)
fxo-ring-timeout
Configures the delay (in 100 msec) for generating
INVITE after RING_START detection. The valid
range is 0 to 50
If not set, the FXO will not seize the line
ground-start-use-ring
Ground start use regular ring
guard-time-btwn-calls
Configures the time interval (in seconds) after a
call has ended and a new call can be accepted for
IP-to-Tel calls
Enables the PSAP Call flow
To Next Page
Loading...
