AudioCodes Mediant MSBR Series User Manual (English)

To Next Page

To Previous Page

Reference Guide 584 Document #: LTRT-17939

Mediant MSBR

74.2.10.2 bfd neighbor

This command is used to define a BFD neighbor. To set BFD OSPF timers, see Section

75.2.2.79.3.11 on page 712.

Syntax

bfd neighbor <neighbor id> <ip address> <interface ID> interval

<value> min_rx <value> multiplier <value> [multihop]

Command Description

neighbor id (1-20) Neighbor identifier

ip address Address of the remote BFD device

interface id Name and number of the outgoing interface

interval (200-30000) Desired interval for outgoing bfd messages in

milliseconds. The interval will be increased if the remote system

requires it.

min_rx

(200-30000) Minimal interval between bfd messages in

milliseconds. The remote system will use this interval for

sending messages in case its interval is lower.

multiplier (1-20) Maximum number of packets that can be missed before

the session status is considered down.

multihop Set the neighbor to multihop mode in case the remote device is

not on the local LAN.

Default

N/A

Command Mode

Privileged User

Related Commands

show data bfd neighbors, ip route

Example

This example configures a BFD neighbor with ip address 192.168.0.100 on vlan 1

(config-data)# bfd neighbor 1 192.168.0.100 vlan 1 interval 200

min_rx 200 multiplier 3

Other manuals for AudioCodes Mediant MSBR Series

Need help?

Do you have a question about the AudioCodes Mediant MSBR Series and is the answer not in the manual?

General