AudioCodes Mediant MSBR Series

Reference Guide 96 Document #: LTRT-17939
Mediant MSBR
Note
If you have not enabled logging of user activities in the management interface, nothing is
displayed in the output of this show command. To enable logging, see the following
command:
configure troubleshoot > activity-log
Related Command
configure troubleshoot > activity-log – enables logging of activities
Example
This example displays the logged messages:
show system log
Jan 4 00:44:39 local0.notice [S=4666] [BID=5b1035:208]
HTTPTaskHCTL - Run selfCheck
Jan 4 00:45:40 local0.notice [S=4667] [BID=5b1035:208]
HTTPTaskHCTL - Run selfCheck
6.2 show admin state
This command displays the device's current administrative state (locked or unlocked).
Syntax
show admin state
Command Mode
Basic and Privileged User
Related Command
admin state – locks or unlocks the device.
Example
This example displays the administrative state of the device (which is unlocked):
# show admin state
current admin-state: unlock
6.3 show data
These commands display data-router functionality.
Syntax
show data