AudioCodes Mediant MSBR Series

Reference Guide 602 Document #: LTRT-17939
Mediant MSBR
75.1.2.2 ipv6 access-list
This command adds an access list entry.
Syntax
# ipv6 access-list resequence <ipv6 access-list name> <starting
rule number> <step size>
# ipv6 access-list extended <extended IPv6 access-list number>
# ipv6 access-list <access-list ID> {deny|permit} <protocol>
<address1> <address2>
# ipv6 access-list <access-list ID> {deny|permit} <protocol>
<address1> <address2> <port desc>
# ipv6 access-list <access-list ID> {deny|permit} <protocol>
<address1> <address2> <port desc> <postacl>
Command Description
starting rule number Defines the starting rule number [1-2147483647].
step size Defines the step size.
protocol Can be any of the following:
• tcp
• udp
• ah
• esp
• gre
• icmp
• igmp
• ipv6
•
[0-255] ipv6 protocol number
address1 Can be any of the following:
• any - any host
• host – single host
• local
• A:B:C::D/P - Defines the network IPv6 address and
prefix.
address2 Can be any of the following:
• any
• host
• local
• A:B:C::D/P - Defines the network IPv6 address and
prefix
• eq
•
range