AudioCodes Mediant MSBR Series

Reference Guide 418 Document #: LTRT-17939
Mediant MSBR
Command Description
ipm-detectors-enable
Enables DSP IP Media Detectors.
Command Mode
Privileged User
Example
This example enables AD:
(config-voip)# media ipmedia
(media-ipmedia)# answer-detector-enable on
(media-ipmedia)# activate
63.3 rtp-rtcp
This command configures various RTP-RTCP parameters.
Syntax
(config-voip)# media rtp-rtcp
(media-rtp-rtcp)#
Command Description
AnalogSignalTransportT
ype
Defines the analog signal transport type.
EnableStandardSIDPaylo
adType
Defines the Silence Indicator (SID) packets that are sent
and received are according to RFC 3389.
L1L1ComplexTxUDPPort
Defines the Source UDP port for the outgoing UDP
Multiplexed RTP packets, for Complex-Multiplex RTP
mode
RTPFWInvalidPacketHand
ling
Defines the way an invalid packet should be handled.
RTPPackingFactor
Defines the number of DSP payloads for generating one
RTP packet.
RtpFWNonConfiguredPTHa
ndling
Defines the the way a packet with non-configured payload
type should be handled.
VQMONBURSTHR
Defines the voice quality monitoring - excessive burst alert
threshold
VQMONDELAYTHR
Defines the voice quality monitoring -
excessive delay alert
threshold
VQMONEOCRVALTHR
Defines the voice quality monitoring - end of call low
quality alert threshold
VQMONGMIN
Defines the voice quality monitoring - minimum gap size
(number of frames)
base-udp-port
Defines the lower boundary of UDP ports to be used by the
board.