AudioCodes Mediant MSBR Series User Manual

Reference Guide 36 Document #: LTRT-17939
Mediant MSBR
3.5.2 Adding New Rows to Specific Indices
You can add a new row to any specific index number in the table, even if a row has already
been configured for that index. The row that was assigned that index is incremented to the
next consecutive index number, as well as all the index rows listed below it in the table.
Syntax
# <table name> <row index> insert
Note
The command is applicable only to the following tables:
 SBC:
• IP-to-IP Routing
• Classification
• Message Condition
• IP-to-IP Inbound Manipulation
• IP-to-IP Outbound Manipulation
 SBC and Gateway:
• Message Manipulations
 Gateway:
• Destination Phone Number Manipulation Tables for IP-to-Tel / Tel-to-IP Calls
• Calling Name Manipulation Tables for IP-to-Tel / Tel-to-IP Calls
• Source Phone Number Manipulation Tables IP-to-Tel / Tel-to-IP Calls
• Redirect Number Tel-to-IP
Command Mode
Privileged User
Example
If the IP-to-IP Routing table is configured with three existing rows (ip2ip-routing-0, ip2ip-
routing-1, and ip2ip-routing-2) and a new row is added at Index 1, the previous ip2ip-routing-
1 becomes ip2ip-routing-2, the previous ip2ip-routing-2 becomes ip2ip-routing-3, and so on:
(config-voip)# sbc routing ip2ip routing 1 insert
(ip2ip-routing-1)#

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English