Reference Guide 666 Document #: LTRT-17939
Mediant MSBR
Command Description
neighbor tag Defines the neighbor tag.
Default
NA
Command Mode
Privileged User
Example
This is an example of how this command can be used.
(config-data)# router bgp 1
(conf-router)# neighbor 10.14.3.11 transparent-as
75.2.2.52 neighbor timers
This command sets the timers for a specific BGP neighbor. Keepalive messages are sent by
a router to inform another router that the BGP connection between the two is still active.
Syntax
neighbor {<neighbor tag>|a.b.c.d|X:X::X:X} timers connect <timer>
neighbor {<neighbor tag>|a.b.c.d|X:X::X:X} timers <keepalive>
<holdtime>
Command Description
a.b.c.d|X:X::X:X Defines the IP address of the neighbor (IPv4 or IPv6).
neighbor tag Defines the neighbor tag.
timer Defines the connect timer (0-65535).
keepalive Defines the frequency (in seconds) with which keepalive
messages are sent to its peer (0–65535).
holdtime Defines the interval (in seconds) after not receiving a
keepalive message (0-65535).
Default
NA
Command Mode
Privileged User
Example
This is an example of how this command can be used.
(config-data)# router bgp 1
To Next Page
Loading...
