AudioCodes Mediant MSBR Series User Manual

Reference Guide 512 Document #: LTRT-17939
Mediant MSBR
73.3 ADSL/VDSL Commands
The following describes ADSL/VDSL commands.
73.3.1 interface dsl 0/0
Asymmetric Digital Subscriber Line (ADSL) and VDSL (Very high-speed DSL) are popular
WAN access technologies using copper wire pairs.
On appropriate hardware variants of the device, this command defines the physical properties
of the ADSL/VDSL interface.
Once the physical layer is configured:
 For ADSL, proceed to ATM interfaces using the command "interface atm".
 For VDSL, proceed to configure WAN Ethernet using the command “interface
GigabitEthernet 0/0”.
 The DSL interface automatically detects the signal on the interface and based on the
signal it chooses the DLS mode (ADSL or VDSL).
Syntax
interface dsl <slot>/<port>
Command Description
<slot> Defines the location of the ADSL hardware mezzanine. Must be 0.
<port> Defines the location of the ADSL hardware mezzanine. Must be 0.
Default
By default, the DSL interface is not defined.
Command Mode
Privileged User.
Example
The example below describes how to define the DSL interface.
(config data)# interface dsl 0/0

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English