AudioCodes Mediant MSBR Series - Debug Phy-Err-Injection

Reference Guide 78 Document #: LTRT-17939
Mediant MSBR
5.23 debug phy-err-injection
This command debugs the Rx physical error injection.
Syntax
# debug phy-err-injection
Command Description
set delay-depth <Value>
Configures the delay depth, in packets
set delay-rate <Value>
Configures the delay rate
set drop-rate <Value>
Configures the drop rate
set interface
{atm|efm|fiber|gigabitethernet}
Configures the interface to run the Rx
error on:
 atm <Group/Subinterface>
 efm <Slot/Port.vlanID>
 fiber <Slot/Port>
 gigabitethernet <Slot/Port.vlanID>
Example: 0/0.150 where slot=0, port=0
and vlanID=150
show
Shows the configuration of the Rx
physical error injection.
start
Starts the Rx physical error injection.
stop
Stops the Rx physical error injection.
Command Mode
Privileged User
Note
This command is applicable only to data-router functionality.
Example
This example starts debugging the RX physical error injection on the Gigabit Ethernet
interface, slot 0, port 0 and VLAN ID 150:
# debug phy-err-injection set interface gigabitethernet 0/0.150