AudioCodes Mediant MSBR Series - Ip Address

Reference Guide 540 Document #: LTRT-17939
Mediant MSBR
Command Mode
Privileged User
Example
This example sets the mrru to 500 bytes on multilink interface 1:
(conf-if-multilink 1)# ppp mrru 500
73.4.16.5 ip address
This command specifies the IP addressing mode of this multilink interface.
Syntax
ip address <mode> <a.b.c.d> <e.f.g.h>
Command Description
mode Defines the MLP IP addressing modes as follows:
 ‘automatic’ – IP address will be accepted from peer during PPP
negotiation.
 ‘manual’ – set local static IP address and optional subnet mask.
 ‘unnumbered’ – use unnumbered mode (MLP serial interface
uses LAN interface ip address).
a.b.c.d
Defines the static local IP address set on this MLP multilink interface
– relevant for manual mode only.
e.f.g.h Defines the optional static subnet mask set on this MLP multilink
interface - relevant for manual mode only.
Default
By default the IP addressing is automatic.
Command Mode
Privileged User
Example
This example sets the IP address 223.4.5.6 on multilink interface 0:
(conf-if-multilink 0)# ip address manual 223.4.5.6
This example sets the IP addressing mode to automatic on multilink interface 0:
(conf-if-multilink 0)# ip address automatic