Reference Guide 466 Document #: LTRT-17939
Mediant MSBR
Command Description
registrar-search-mode
{by-ims-spec|current-
server}
Defines the method for choosing an IP address (registrar)
in the Proxy Set (associated with the Serving IP Group) to
which the Account initially registers and performs
registration refreshes, when the Register Stickiness
feature is enabled.
registrar-stickiness
{disable|enable}
Enables the "Registrar Stickiness" feature, whereby the
device always routes SIP requests of a registered Account
to the same registrar server to where the last successful
REGISTER request was routed.
served-ip-group-name
Defines the IP Group (e.g., IP-PBX) that you want to
register and/or authenticate upon its behalf.
served-trunk-group
Defines the Trunk Group that you want to register and/or
authenticate.
serving-ip-group-name
Defines the IP Group (Serving IP Group) to where the
device sends the SIP REGISTER requests (if enabled) for
registration and authentication (of the Served IP Group).
udp-port-assignment
{disable|enable}
Enables the device to dynamically allocate local SIP UDP
ports to Accounts using the same Serving IP Group, where
each Account is assigned a unique port on the device's
leg interfacing with the Accounts' Serving IP Group.
Defines the digest MD5 Authentication username.
Command Mode
Privileged User
Example
This example configures an Account with a username and password that registers IP Group
"IPBX" with IP Group "ITSP":
(config-voip)# sip-definition account 0
(account-0)# user-name JoeD
(account-0)# password 1234
(account-0)# register reg
(account-0)# served-ip-group-name IPPBX
(account-0)# serving-ip-group-name ITSP
(account-0)# activate
69.2 least-cost-routing cost-group
This command configures Least Cost Routing (LCR). This command configures the Cost
Groups table, which lets you define Cost Groups. A Cost Group defines a fixed call
connection cost and a call rate (charge per minute).
Syntax
(config-voip)# sip-definition least-cost-routing cost-group
<Index>
(cost-group-<Index>)#