Reference Guide 518 Document #: LTRT-17939
Mediant MSBR
Example
This example selects automatic line rate:
(conf-shdsl-0)# linerate auto
73.4.7 annex
This command selects the regional annex (as defined in ITU-T Recommendation G.991.2)
for an SHDSL group.
Syntax
interface shdsl 0/0
group <group-id>
annex {a|b}
Command Description
a Selects G.991.2 regional annex A / F.
b Selects G.991.2 regional annex B / G.
Default
The default setting is annex a.
Command Mode
Privileged User
Note
Annex F is identical to Annex A, with extended line rates up to 5696 Kbps. Similarly, Annex
G is identical to Annex B with extended line rates up to 5696 Kbps.
Example
This example selects regional annex A:
(conf-shdsl-0)# annex a
73.4.8 interface atm
This command defines an ATM sub-interface for Internet access over SHDSL. An ATM sub-
interface provides IP services over a Permanent Virtual Circuit (PVC) defined by the ATM
network administrator.
Syntax
interface atm <group-id>/<sub-id>
To Next Page
Loading...
