Reference Guide 190 Document #: LTRT-17939
Mediant MSBR
8.2 copy
This command downloads / uploads files to / from the device.
Syntax
# copy <File Type> {from|to} {<URL>|console|usb:///<Filename>}
Command Description
File Type
aux-package
Configures the type of file as an auxiliary package file,
allowing you to download or upload a batch of auxiliary
files, using a TAR (Tape ARchive) file (.tar).
The TAR file can contain any number and type of Auxiliary
files, for example, a Dial Plan file and a CPT file.
Note: The file can be uploaded or downloaded (see
commands 'from' and 'to' below).
call-progress-tones
Configures the type of file as a Call Progress Tones (CPT)
file.
Note: The file can only be uploaded to the device (see the
command 'from' below).
cas-table
Configures the type of file as a Channel Associated
Signaling (CAS) table file.
Note: The file can only be uploaded to the device (see the
command 'from' below).
cli-script
Configures the type of file as a CLI script file.
Note: The file can be uploaded or downloaded (see
commands 'from' and 'to' below).
debug-file
Configures the type of file as a debug file and copies the
file from the <device> to a destination. The debug file
contains the following information:
• Exception information, indicating the specific point in the
code where the crash occurred and a list of up to 50 of
the most recent SNMP alarms that were raised by the
<device> before it crashed.
• Latest log messages that were recorded prior to the
crash.
• Core dump. The core dump is included only if core
dump generation is enabled, no IP address has been
configured, and the <device> has sufficient memory on
its flash memory.
May include additional application-proprietary debug
information. The debug file is saved as a zipped file with
the following file name: "debug_<device
name>_ver_<firmware version>_mac_<MAC
address>_<date>_<time>". For example,
debug_acMediant_ver_700-8-4_mac_00908F099096_1-
03-2015_3-29-29.
Configures the type of file as a Dial Plan file.