AudioCodes Mediant MSBR Series - Sbc-Alt-Routing-Reasons

Version 7.2 457 Mediant MSBR
Reference Guide 68. sbc
Command Description
trigger {3xx|3xx-or-
refer|any|broken-
connection|fax-
rerouting|initial-
only|refer}
Defines the reason (i.e., trigger) for re-routing (i.e.,
alternative routing) the SIP request.
Command Mode
Privileged User
Example
This example configures a routing rule for calls from IP Group "IPBX" to IP Group "ITSP":
(config-voip)# sbc routing ip2ip-routing 0
(ip2ip-routing-0)# route-name IPPBX-TO-SIPTRUNK
(ip2ip-routing-0)# src-ip-group-name IPBX
(ip2ip-routing-0)# dst-type ip-group
(ip2ip-routing-0)# dst-ip-group-name ITSP
(ip2ip-routing-0)# activate
68.6.4 sbc-alt-routing-reasons
This command configures the Alternative Routing Reasons table, which lets you define SIP
response codes for call release (termination) reasons that initiate alternative routing.
Syntax
(config-voip)# sbc routing sbc-alt-routing-reasons <Index>
(sbc-alt-routing-reasons-<Index>)#
Command Description
rel-cause {400-bad-req|402-payment-
req|403-forbidden|404-not-found|405-
method-not-allowed|406-not-acceptable|408-
req-timeout|409-conflict|410-gone|413-req-
too-large|414-req-uri-too-long|415-unsup-
media|420-bad-ext|421-ext-req|423-session-
interval-too-small|480-unavail|481-
transaction-not-exist|482-loop-
detected|483-too-many-hops|484-address-
incomplete|485-ambiguous|486-busy|487-req-
terminated|488-not-acceptable-here|491-
req-pending|493-undecipherable|4xx|500-
internal-err|501-not-implemented|502-bad-
gateway|503-service-unavail|504-server-
timeout|505-version-not-supported|513-
message-too-large|5xx|600-busy-
everywhere|603-decline|604-does-not-exist-
anywhere|606-not-acceptable|6xx|805-
admission-failure|806-media-limits-
exceeded|850-signalling-limits-exceeded}
Defines a SIP response code for
triggering the <device>'s
alternative routing mechanism.