AudioCodes Mediant MSBR Series User Manual

Version 7.2 351 Mediant MSBR
Reference Guide 58. coders-and-profiles
Command Description
fxo-ring-timeout
Configures the delay (in 100 msec) for generating an
INVITE after RING_START is detected.
input-gain
Configures the TDM input gain.
ip2tel-
cutthrough_call_behavio
r
Enables a call connection without an On-Hook/Off-Hook
process.
is-two-stage-dial
Configures Dialing Mode - One-Stage (PBX Pass-thru) or
Two-Stage.
jitter-buffer-maximum-
delay
Configures the maximum delay (in msec) for the Dynamic
Jitter Buffer.
jitter-buffer-minimum-
delay
Configures the minimum delay (in msec) for the Dynamic
Jitter Buffer.
jitter-buffer-
optimization-factor
Configures the Dynamic Jitter Buffer frame error-delay
optimization factor.
mwi-analog-lamp
Enables MWI support using an analog lamp (110 Volt).
mwi-display
Enables MWI support using Caller ID interface.
mwi-ntf-timeout
Defines the maximum duration (timeout) that a message
waiting indication (MWI) is displayed on endpoint
equipment (phones' LED, screen notification or voice
tone).
play-bsy-tone-2tel
Configures Don't play, Play Busy or Reorder tone when
disconnecting ISDN call and Send PI=8, Play before
disconnect.
polarity-rvrsl
Enables Polarity Reversal.
profile-name
Configures the Profile Name (string).
prog-ind-to-ip
Determines whether to send the Progress Indicator to IP.
rtp-ip-diffserv
Configures the RTP IP DiffServ.
signaling-diffserv
Configures the SIP Signaling DiffServ.
swap-teltoip-phone-
numbers
Swaps Tel to IP phone numbers.
tel-preference
Configures the Profile Preference - the priority of the Tel
Profile.
time-for-reorder-tone
Configures the duration of the reorder tone that plays
before the FXO releases the line [seconds].
voice-volume
Configures the voice TDM output gain.
Command Mode
Privileged User
Example
This example configures a Tel Profile:

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English