AudioCodes Mediant MSBR Series User Manual

Version 7.2 461 Mediant MSBR
Reference Guide 68. sbc
Command Description
end-point-call-
priority
Defines the ports call priority.
enforce-media-order
Arrange media lines according to the previous offer-
answer (required by RFC 3264).
enforce-media-order
Enforces media order according to RFC 3264.
gw-direct-route-prefix
Defines the prefix for call redirection from SBC to
Gateway.
keep-contact-user-in-
reg
Keeps original Contact User in REGISTER requests.
lifetime-of-nonce
Defines the lifetime of the nonce in seconds.
media-channels
Defines the number of channels associated with media
services (announcements, conferencing).
min-session-expires
Defines the the minimum amount of time that can occur
between session refresh requests in a dialog before the
session is considered timed out.
min-session-expires
Defines the minimal value for session refresh.
no-rtp-detection-
timeout
Defines the timeout for RTP detection after call connect
(msec).
num-of-subscribes
Defines the active SUBSCRIBE sessions limit.
p-assert-id
0 - As Is,1- Add P-Asserted-Identity Header, 2 - Remove
P-Asserted-Identity Header
sas-notice
If enabled - when SBC needs to terminates a REGISTER
request, it adds a body (survivability notice) to the 200OK
response.
sbc-100trying-upon-
reinvite
Defines whether or not to response with 100 trying to re-
INVITE request.
sbc-3xx-bhvt
Defines how the device passes Contact in 3xx responses.
sbc-broadworks-
survivability
Indicates how the registration database is provisioned.
sbc-bye-auth
Allows the media to remain active upon receipt of a
401/407 response by sending a releaseNackEvent, rather
than releaseEvent.
sbc-db-route-mode
Defines the database binding mode for routing search.
sbc-dialog-info-
interwork
Changes the WAN call identifiers in the dialog-info body of
NOTIFY messages to LAN call identifiers.
sbc-dialog-subsc-
route-mode
Determines where in-dialog refresh subscribes are sent.
sbc-direct-media
{off|on}
Enables direct media.
sbc-diversion-uri-type
Defines which URI to use for Diversion header.
sbc-dtls-mtu
Defines the DTLS max transmission unit.
sbc-emerg-condition
Defines the Emergency Message Condition.

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English