AudioCodes Mediant MSBR Series - Page 710

Reference Guide 710 Document #: LTRT-17939
Mediant MSBR
75.2.2.79.3.7 ip ospf network
This command explicitly sets the network type for the specified interface.
Syntax
ip ospf network {broadcast|non-broadcast|point-to-multipoint
|point-to-point}
no ip ospf network
Command Description
broadcast Specifies the OSPF broadcast multi-access network.
non-broadcast Specifies the OSPF NMBA network.
point-to-multipoint Specifies the OSPF point-to-multipoint network.
point-to-point Specifies the OSPF point-to-point network.
Default
NA
Command Mode
Privileged User
Example
This example explicitly sets the network type for the specified interface.
(config-data)# interface vlan1
(conf-if-VLAN 1)# ip ospf network point-to-point
75.2.2.79.3.8 ip ospf priority
This command sets the RouterPriority integer value.
Syntax
ip ospf priority number [a.b.c.d]
no ip ospf priority [a.b.c.d]
Command Description
number Defines the priority value in the range of 0-255.
a.b.c.d Address of the interface
Default
1