AudioCodes Mediant MSBR Series User Manual

Version 7.2 717 Mediant MSBR
Reference Guide 75. Layer-3 Commands
Command Mode
Privileged User
Example
This example enables RIPng configuration mode.
(config-data)# router ripng
75.2.2.81.1.3 passive-interface
This command sets the specified interface to passive mode. On passive mode interfaces, all
receiving packets are processed as normal and ripd does not send either multicast or unicast
RIP packets except to RIP neighbors specified with the neighbor command. The interface
may be specified as ‘default’ to make ripd default to passive on all interfaces. The default is to
be passive on all interfaces.
Syntax
passive-interface {ifname|default}
no passive-interface ifname
Interface Type (ifname) Interface ID
gigabitethernet
GigabitEthernet interface slot
and port (VLAN ID is optional)
[SLOT/PORT.VLANID]
cellular Cellular interface ID 0/0
gre Tunnel GRE ID [1-255]
ipip Tunnel IPIP ID [1-255]
l2tp L2TP ID [0-99]
pppoe PPPoE interface ID [1-3]
pptp PPTP ID [0-99]
vlan Vlan ID [1-3999]
loopback Loopback ID [1-5]
bvi Bridge interface [1-255]
Default
NA
Command Mode
Privileged User
Example
This example sets the specified interface to passive mode.
(config-data)# router rip

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English