HEIDENHAIN iTNC 530 HSCI - Page 517

July 2013 4.4 List of machine parameters 517
MP2222.x Special controller functions
Format: %xxxxxxxxxxxxxxxx
Input:
Bit 2 – CC 61xx, EnDat 2.2: Temperature signal not from
EnDat 2.2-log but from KTY input
0: Inactive
1: Temperature signal from KTY input
Bit 10 – Special sequence for wye/delta switchover on
asynchronous motors: Activate the power
module and the current controller
simultaneously
0: Not active
1: Active
Bit 11 – Special sequence for wye/delta switchover on
asynchronous motors: Demagnetize the motor
during switch-off
0: Not active
1: Active
606 42x-02
613
984
MP2223.x Special controller functions
Format: %xxxxxxxxxxxxxxxx
Input:
Bit 1 – Automatically take the holding torque from MP2630
in PLC Module 9128/9158 into account
0: Not active
1: Active
Bit 7 – Wait for readiness of current controller
0: Wait for readiness of current controller
1: Do not wait for readiness of current controller
606 42x-02
60642x-03
875
982
MP Function and input Software
version and
behavior
Page