July 2013 4.4 List of machine parameters 575
MP7680 Machine parameter with multiple function
Bit 8 – Insertion of rounding arc or cubic spline
0: Rounding arc is inserted
1: A cubic spline is inserted instead of a rounding arc
Bit 9 – Constant jerk on spline (bit 8 = 1)
0: No constant jerk
1: Constant jerk
Bit 10 – Cutter-radius-compensated outside corners
0: Insertion of a circular arc
1: Insertion of a spline curve
Bit 11 – Behavior of M116
0: Rotary axis is parallel to linear axis
1: Any position of rotary axis to linear axis
Bit 12 – Behavior of Cycle 28
0: Standard behavior
1: The slot wall is approached and departed tangentially; at
the beginning and end of the slot a rounding arc
with a diameter equal to the slot width is cut
Bit 13 – Behavior during program interruption with axis
movement
0: Automatic activation of APPROACH POSITION
1: Do not automatically activate APPROACH POSITION
Bit 14 – Behavior of NC start after NC stop and internal stop
0: NC start permitted
1: NC start only permitted after block scan (GOTO)
Bit 15 – NC Start if program is aborted
0: NC start permitted
1: NC Start not permitted (message window)
Bit 16 – Behavior of Cycle 39
0: Approach/departure movement on an arc is active
1: Approach/departure movement on an arc is not active
Bit 17 – Behavior of Markers M4175 and M4176
0: Clear M4175 and M4176 upon internal stop
1: M4176 remains set during RUNCANCEL macro
Bit 18 – Manual measurement of basic rotation with inclined
rotary axes
0: Error message "Axis angle not equal to tilt angle" is active
1: Error message not active
PLC
RUN
892,
893,
1217,
1243,
1246,
1404,
1595,
1160
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
