HEIDENHAIN iTNC 530 HSCI - Page 593

July 2013 5.2 Overview of markers and words 593
M 4093 Acknowledgment of T code (P code) with
TOOL CALL
PLC PLC 1611,
1629
M 4094 Acknowledgment of T code (P code) with
TOOL DEF
PLC PLC 1611,
1629
M 4095 Acknowledgment of transfer with FN19 PLC PLC 1713
M 4120 -
4128
PLC positioning axis 1 to 9 active NC/PLC NC/
PLC
646
M 4130 Activation of spindle orientation, or spindle
orientation has been started with Module
9171
NC/PLC NC 973
M 4131 Activation of Q-parameter transfer to the
NC; data from D258, Q number from
W516
PLC NC 1714
M 4132 Activate datum shift from D528 to D544,
or call Module 9230
PLC NC 1534
M 4133 Start and stop the free rotation function PLC NC 1154
M 4134 Activation of a gear range and speed
through the PLC
PLC NC 960
M 4135 Strobe marker for selecting the traverse
range
PLC NC 624
M 4150 Operating mode: Manual Operation NC NC 1165
M 4151 Operating mode: Electronic Handwheel NC NC 1165
M 4152 Operating mode marker
 Positioning with Manual Data Input
 RUN ACTIVE UNIT
NC NC 1165
M 4153 Operating mode marker
 Program Run, Single Block
 RUN SINGLE UNITS
NC NC 1165
M 4154 Operating mode marker
 Program Run, Full Sequence
 RUN ALL UNITS
NC NC 1165
M 4155 Operating mode: Traversing the reference
marks
NC NC 1165
M 4156 MANUAL TRAVERSE soft key pressed NC NC 1246
M 4157 Returning to the contour (MOVE TO
POSITION) is active
NC NC 1246
M 4158 Block scan active NC NC 1246
M 4159 PLC editor: END key or soft key pressed NC NC/
PLC
1417
M 4160 Pallet table selected NC NC 1496
M 4161 M/S/T/Q transfer after block scan NC NC 1248
M 4162 DNC mode (0 = DNC inactive, 1 = DNC
active)
NC NC
M 4163 Alternative operating mode smarT.NC is
active
NC NC 1165
Operand Description Set Reset SW version Page