HP Latex 300 Series

Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
▲
Check that PZ 1 fan is properly connected. If it is, then replace PZ 1 fan.
SE Code: 15.62:10 – PZ fan 2 fault or not connected
Problem description:
PZ fan 2 disconnected or damaged.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
▲
Check that PZ 2 fan is properly connected. If it is, then replace PZ 2 fan.
SE Code: 15.63:10 – PZ fan 3 fault or not connected
Problem description:
PZ fan 3 disconnected or damaged.
Corrective action:
Service engineer:
▲
Check that PZ 3 fan is properly connected. If it is, then replace PZ 3 fan.
SE Code: 15.69:10 – More than 1 PZ fan fault or not connected
Problem description:
PZ Heaters Fan Cable PZ Resistor Fan 1 Air Curtain and Printzone Heaters Control PCA.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Reseat/Replace Air Curtain and Printzone Heaters Control PCA to PZ Heaters Fan cable.
2. Reseat/Replace PZ Resistor Fan 1.
SE Code: 15.71:10 – PZ fan 1: fan or cable damaged
Problem description:
Fan or cable damaged.
Corrective action:
ENWW Continuable and non-continuable error codes 93