HP Latex 300 Series

SE Code: 42:10 – Scan axis motor fault detected
Problem description:
Scan axis failure.
Corrective action:
Service engineer:
▲
Replace the Scan-Axis Motor.
SE Code: 42:11 – Scan axis motor disconnected
Problem description:
The Scan axis motor has become disconnected.
Corrective action:
Service engineer:
▲
Reconnect the Scan Axis Motor. See
Scan-axis motor on page 319
SE Code: 43:11 – Vacuum fan not connected
Problem description:
Vacuum fan not connected.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Check the cable connections between the Mini Interconnect PCA and Eola SVS side.
2. Replace Eolas.
3. Replace the Mini Interconnect PCA.
SE Code: 43.1:11 – Communication error: Problem in communication with vacuum
board fan
Problem description:
Eola PCA is not connected. Eola PCA is damaged. Cable between Eola PCA and Interconnect PCA is damaged.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Check the cable connections between Interconnect PCA and EOLA PCA.
2. Replace the EOLA PCA.
ENWW Continuable and non-continuable error codes 119